Quantcast
Follow Us:
My Account: Log In Log Out
view cart
0 item(s) in cart/ total: $0
Rust Preventive Coating
Preparation Products
Bed Liner
Paint Remover
Floor Armor Concrete Coating
Primers
Single Part Topcoats
2 Part Topcoats
Engine Enamel
High Temperature Paints
Putty, Fillers & Undercoating
Complete Kits
Fuel System Restoration
Accessories & Specialty
Shirts








Home>Product Info>Epoxy Putty Test Results
 

Epoxy Putty Test Results

Epoxy PuttyT Performance Test Results

Structural Strength Measures 

ASTM D - 638 - Standard Test Method for Tensile Properties of Plastics. This test method covers the determination of the tensile properties of unreinforced and reinforced plastics in the form of standard dumbbell-shaped test specimens when tested under defined conditions of pretreatment, temperature, humidity and testing machine speed. 
4,000 psi
ASTM D - 695 - This test method covers the determination of the mechanical properties of unreinforced and reinforced rigid plastics, including high-modulus composites, when loaded in compression, at relatively low uniform rates of straining or loading.

Compression tests provide information about the compressive properties of plastics when employed under conditions approximately those under which the tests are made. For many materials, there may be a specification that requires the use of this test method, but with some procedural modifications that take precedence when adhering to the specification.

 
12,000 psi
ASTM D - 1002- This test method covers the determination of the apparent shear strengths of adhesives for bonding metals when tested on a standard single-lap-joint specimen and under specified conditions of preparation and test 
300 volts/mil


Electrical

ASTM D 149 - This test method covers procedures for the determination of dielectric strength of solid insulating materials at commercial power frequencies, under specified conditions.This test method is most commonly used to determine the dielectric breakdown voltage through the thickness of a test specimen (puncture). It may also be used to determine dielectric breakdown voltage along the interface between a solid specimen and a gaseous or liquid surrounding medium (flashover). 
300 volts/mil.