Follow Us:
My Account: Log In Log Out
view cart
0 item(s) in cart/ total: $0
Rust Preventive Coating
Rust Remover
Matte Clear Coat
Preparation Products
Bed Liner
Paint Remover
Concrete Floor Coatings
Single Part Topcoats
2 Part Topcoats
Engine Enamel
High Temperature Paints
Putty, Fillers & Undercoating
Complete Kits
Fuel Tank Restoration
Accessories & Specialty

POR-15 Weld-Thru Primer

POR-15 Weld-Thru Primer

Item Id: 41418
Review this item Review this item
In Stock

Weldable Zinc Enriched Primer - 15 oz. Spray

  • Minimizes Heat Zone During Welding
  • Reduces Welding Distortion and Splatter
  • Provides Corrosion Resistance to Welding Surfaces
Professional Use POR-15® Weld-Thru Primer can be applied over cured POR-15® Rust Preventive Coating and all POR-15® topcoats to enable quick refinishing and recoating of these products. POR-15® Weld-Thru Primer also adheres well to steel, aluminum, stainless steel, brass, and other primed and painted surfaces.


  • Excellent for use over cured POR-15® Rust Preventive Coating
  • Minimizes heat zone during welding
  • Provides corrosion resistance to welding surfaces
  • Leaves surface strong and protected
  • Water resistant after 15 minutes
  • Topcoat in 30 minutes


For maximum adhesion sand surfaces to be painted with 320 grit sandpaper. All surfaces must be clean and free of all dirt, loose rust, oil, grease, wax, soap, loose paint and any other matter. Clean painted and bare metal surfaces with POR-15® Cleaner Degreaser. Metal surfaces should be treated with POR-15® Metal Prep for maximum adhesion. Previously Painted Areas: Scuff surface with 320 grit sand paper. Use POR-15® Cleaner Degreaser and POR-15® Metal Prep. Let surface dry thoroughly. Bare Steel or Aluminum: Clean and prep surface then let dry thoroughly. 


Shake can well before spraying. Spray two light coats of POR-15® Weld-Thru Primer and allow 10 to 15 minutes between coats. POR-15® Weld-Thru Primer can be topcoated in 30 minutes. It is not necessary to sand POR-15® Weld-Thru Primer before topcoating. Dry time: It cures to touch in 30-60 minutes. Second coat can be applied in 10-15 minutes, depending on ambient temperature and humidity. Cleanup: To prevent clogs in spray nozzle, hold can upside down and spray until clear gas appears. Empty aerosol cans are recyclable or may be discarded in regular trash pick-up. Do not incinerate or compact.

- POR-15 Weld-Thru Primer Technical Data Sheet
- POR-15 Weld-Thru Primer MSDS

Related Items
POR-15 Rust Preventive Coating
POR-15 Rust Preventive Coating
Price: $35.11
POR-15 Detail Paint
POR-15 Detail Paint
Price: $27.74
POR-15 2K Urethane
POR-15 2K Urethane
Price: $77.22